Short Description
Allied Machine and Eng. 250Y0H-075F Series Y - 3/4" Straight SH x 7-9/16" OAL - T-A Spade Drill HolderFull Description
| Cutting Diameter (DC) | 3/8" to 27/64" | Shank Length (LS) | 2-1/32" |
| Usable Length (LU) | 4-3/8" | Measurement Type | Fractional |
| Shank Type | Round | Flute Type | Helical |
| Connection Diameter Machine Side (DCONMS) | 3/4" | Decimal Equivalent | 0.375" to 0.421875" |
| Protruding Length (LPR) | 5-17/32" |
? T-A® Drill Insert HoldersCoolant Fed Flanged and Straight Shank ? T-A® Drill Insert holders are also available in XLand 3XLlengths including metric versions of most sizes. Call for pricing. When using the Extended, Long, XL and 3XL holders without a support bushing, AMEC recommends using a short T-A® holder to establish an initial hole two to three times diameters deep Never start or continue rotation of this tool holder without proper engagement with a work piece or fixture. Failure to do so could result in tool failure and/or personal injury. Series 0.5, 1.5 and 2.5 TA® Drill Insert Holders are available with a larger body diameter than the standard series, which yields added support for drill inserts and higher inertial strength. This reduces holder failure in high torque applications. Call for pricing.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
