396422

BERKSHIRE ESUPPLY Allied Machine and Eng. BA5523010H003I Series 1 3MTx11 5/32" OAL T A Spade Drill Holder

From
$17.79
Learn More
Check Store Availability

We don't have enough stock on hand.

Adding to cart… The item has been added
Added to Cart

Short Description

Allied Machine and Eng. 23010H-003I Series 1-3MT x 11-5/32" OAL - T-A Spade Drill Holder

Full Description

Cutting Diameter (DC) 45/64" to 15/16" Protruding Length (LPR)5-7/8"
Usable Length (LU) 4-3/4" Flute TypeHelical
Shank Type Morse Taper Decimal Equivalent0.703125" to 0.9375"
Connection Diameter Machine Side (DCONMS) 3MT
? T-A® Drill Insert HoldersCoolant Fed Taper Shank ? Series 0.5, 1.5 and 2.5 T-A® Drill Insert Holders ? Are available with a larger body diameter than the standard series, which yields added support for drill inserts and higher inertial strength. This reduces holder failure in high torque applications. Call for pricing. Note: Rotary Coolant Adapters are sold separately.T-A® Drill Insert holders are also available in XLand 3XLlengths including metric versions of most sizes. Call for pricing. When using the Extended, Long, XL and 3XL holders without a support bushing, AMEC recommends using a short T-A® holder to establish an initial hole two to three times diameters deep. Never start or continue rotation of this tool holder without proper engagement with a work piece or fixture. Failure to do so could result in tool failure and/or personal injury.

WASHING INSTRUCTIONS:

Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.

Reviews