This Mr. Heater Workshop Tube Heater is an indoor and outdoor heating solution, providing uniform radiant heat using a compact 3in. aluminized steel U-tube design. Check all local codes and restrictions before installation. Venting required for clean and safe operation.
Features
- 45,000 BTU
- Heats Up to 1,125 Sq. Ft.
- Ships pre-assembled for simple installation
- Provides uniform heat distribution
- Compact aluminized steel U-tube design
- 4? venting connections
- Polished aluminum deep-dish reflector
- Commercial approved
- Indoor / outdoor approved with proper ventilation
- Ships as natural gas
- includes propane conversion kit
Specs
- Power: 45,000 BTU/hr (13.2 kw)
- Voltage: 120V
- Electrical Connection: 3 pin molded plug
- Gas Inlet
- Connection: 1/2 Male NPT
- Pressure for Natural Gas:
- Minimum: 5.0" W.C. (1.25 kPa)
- Maximum: 11.0" W.C. (2.74 kPa)
- Pressure for LPG (Propane):
- Minimum: 11.0" W.C. (2.74 kPa)
- Maximum: 13.0" W.C. (3.24 kPa)
- Pressure for Natural Gas:
- Connection: 1/2 Male NPT
- Manifold Pressure:
- Natural Gas: 4.0" W.C (1 kPa)
- LPG (Propane): 10.0" W.C. (2.49 kPa)
- Venting Specifications
- Air Intake/Venting Pipe Requirements:
- Minimum Length: 3' (0.91m)
- Maximum Length: 25' (7.62m)
- Intake Pipe Diameter: 3.0" (3.62cm)
- Vent Pipe Diameter: 4.0" (10.16cm)
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
