Short Description
Allied Machine and Eng. 24020H-004I Series 2-4MT x 14-25/32" OAL - T-A Spade Drill HolderFull Description
| Cutting Diameter (DC) | 31/32" to 1-3/8" | Protruding Length (LPR) | 8-1/2" |
| Usable Length (LU) | 7-3/8" | Measurement Type | Fractional |
| Shank Type | Morse Taper | Flute Type | Helical |
| Connection Diameter Machine Side (DCONMS) | 4MT | Decimal Equivalent | 0.96875" to 1.375" |
? T-A® Drill Insert HoldersCoolant Fed Taper Shank ? Series 0.5, 1.5 and 2.5 T-A® Drill Insert Holders ? Are available with a larger body diameter than the standard series, which yields added support for drill inserts and higher inertial strength. This reduces holder failure in high torque applications. Call for pricing. Note: Rotary Coolant Adapters are sold separately.T-A® Drill Insert holders are also available in XLand 3XLlengths including metric versions of most sizes. Call for pricing. When using the Extended, Long, XL and 3XL holders without a support bushing, AMEC recommends using a short T-A® holder to establish an initial hole two to three times diameters deep. Never start or continue rotation of this tool holder without proper engagement with a work piece or fixture. Failure to do so could result in tool failure and/or personal injury.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
